iSys iTerra Lite Color Inkjet Printer - Manual (Page 29)

29
d) Position the desktop version input media tray as in figure ‘Install5’, by hanging the tray portion
on the tabs protruding from the base plate.
e) Paper should be installed prior to attaching the output media tray. Place continuous paper in
the input tray, with I-marks face up and on right hand side (as in figure ‘Install6’). Ensuring that
the first sheet fed is a non I-mark sheet, slowly insert the sheet into the lower slot at the front
of printer until resistance is felt (should be approximately eight inches). Press the ‘form feed’
button on the operator panel. The paper will move forward seeking out the first I-mark and
setting the top of form alignment.
DESKTOP OUTPUT TRAY INSTALLATION
Figure # Install 7 Figure # Install 8
a) Using a Phillips screwdriver remove the two screws on the front plate of the printer and
replace with the specialized screws found in the Output Tray Kit. The new screws will require
a slotted screwdriver. Install the replacement screws and tighten firmly. Properly installed
screws will protrude from printer approximately ¼ “ from the printer front plate. Refer to figures
‘Install2 & Install7’ for clarity.
b) Hang the tray portion of the output tray over the new screws installed in step a.
Figure # Install 9 Figure # Install 10
When the paper is properly fed into the printer (first sheet being a non I-mark sheet), output
collection will be uniform and stacked as expected. The output tray will stack or fold up to 500 API
sheets maximum.