iSys iTerra Lite Color Inkjet Printer - Manual (Page 33)

33
Paper should be installed in the rack input bottom tray and fed into the printer before installing the
output tray. Paper should be installed with the black “I-mark” visible on the right hand side. Please
refer to previous instructions on proper paper installation.
Operation
MENU GUIDE SETTINGS
CHANGING MENU SETTINGS
1. To use the Menu you must first press offline.
2. Press Menu (far right button). Press Select
3. To choose a selection – press Select – Press Deselect to save changes
4. To Exit – scroll down to exit, then select.
**If you need to re-boot the printer without using the rear power switch, press and hold the middle
button for 2 seconds. The printer will go into soft power off mode. Press the middle button again
(holding for 2 seconds) and printer will perform reboot sequence.
MENU OPTIONS
Page 1
Plot Control
1 – TOF (Top Of Form) Seek
If “on” media advances to next TOF (I - mark)
If “off” printing will commence immediately (no line up with TOF)
2 – TOF Alignment
Allows you to adjust from 0 – 0.5 inch forward from top of form. The default is 0.20 inches and
goes up and down by 0.02 increments.
3 – EOJ Advance (End of Job)
Allows you to advance paper out of printer from 0 to 12.5 inches
4 – Exit
Pen Maintenance
1 – Pen Clean
Allows you to ensure ink cartridges are free of debris, dust, clogging, etc. Options are “yes” and
“no”.
2 – Pen Alignment
Must be done after install of new ink cartridges to ensure proper alignment between black and
color pens. (Registration). Options are “yes” and “no”.
Printer Test
Test Page – select Test Page to print. Options are “yes” and “no”.
Engine Page – select Engine Page to print. This works best on 8.5x11 cut sheet. Options are “yes”
and “no”.