Casio YA-S10 Setup Guide - Manual (Page 12)

E-11
Getting Ready
You can connect one or two of the CASIO projector models below to the Control Box.
XJ-M140, XJ-M145, XJ-M150, XJ-M155, XJ-M240, XJ-M245, XJ-M250, XJ-M255
XJ-H1600, XJ-H1650, XJ-H1700, XJ-H1750, XJ-H2600, XJ-H2650, XJ-ST145, XJ-ST155
XJ-A131
*, XJ-A141*, XJ-A146*, XJ-A241*, XJ-A246*, XJ-A251*, XJ-A256*
* RS-232C connection of these projector models to the Control Box requires an optionally available
cable (YK-5).
z When connecting two projectors, both of them must have the same output resolution. Use of two
projectors that are the same model is recommended.
z For information about supported projectors, visit the CASIO website.
Make sure you correctly install the projector(s) to be connected to the Control Box, referring to the
applicable user documentation.
Important! Important! Important!
z After you set up the Control Box, projector(s), and projection screen, secure all of these
components to ensure that they will not move during use. If the position of a projector, a
projector zoom or focus setting, or the screen is changed, you will need to perform the
adjustment procedure again from the beginning.
If you have an XJ-SK600 or XJ-SK650 Projector System, refer to the “Getting Ready” section in
the XJ-SK600 Setup Guide or the XJ-SK650 Setup Guide.
Supported Projectors
Projector Installation