Emerson Network Router - Manual (Page 38)

32 ProLink ® II Software for Micro Motion ® Transmitters
Using ProLink II Software
3.8 Viewing meter status
ProLink II allows you to view a variety of status information:
• Connection LED – located in the lower right corner of the main window (see Figure 3-2).
This LED indicates the status of the connection between ProLink II and the transmitter:
- Green – Good connection
- Red – Connection fault
- Gray – No connection
• Device Fault Status LED – located in the lower right corner of the main window (see
Figure 3-2). This LED indicates whether or not alarms are active:
- Green – No active alarms
- Red – One or more active alarms
- Gray – Unknown
See Section 3.9 for more information about alarms.
• Diagnostic Information window – displays sensor diagnostic data
• Output Levels window – displays current data for the transmitter’s mA, frequency, and
discrete outputs, and also displays discrete event status
• Status window – displays alarm status. See Section 3.9 for more information about alarms.
• Alarm Log window – displays alarm status and alarm acknowledgment status. See Section 3.9
for more information about alarms.
• Core Processor Diagnostics window – displays detailed diagnostic data for the core
processor component
Note: The Core Processor Diagnostics window is read-only. If changes are required, contact
Micro Motion.
• FingerPrint window – displays detailed information for both process variable data and sensor
diagnostic data