Emerson Network Router - Manual (Page 7)

Installation and Use Manual 1
Pr
oL
in
k II
Setup
T
ransmitter Star
tup
Usi
ng
Pr
oL
in
k
II
Be
fo
re
Y
o
u
Begin
Chapter 1
Before You Begin
1.1 About this manual
This manual explains how to install the Micro Motion ® ProLink ® II software program, v2.9 and later,
on your personal computer (PC).
This manual also provides an overview of using ProLink II with Micro Motion transmitters. Before
using this instruction manual, the reader should be familiar with the Microsoft Windows operating
system.
There are a number of transmitter and application features that may appear in your ProLink II
installation: for example, the enhanced density application, the petroleum measurement application,
the custody transfer application, event configuration, or display configuration. This manual contains
information on configuring and using the discrete batch application (see Appendix B). For detailed
information on configuring and using other transmitter-specific or application-specific features, see
the appropriate transmitter or application manual. If you still have questions, contact the Micro
Motion Customer Service Department. Telephone numbers are listed in Section 1.5.
1.2 About ProLink II software
This section provides an overview of ProLink II software.
1.2.1 Supported transmitters
The ProLink II program supports the following Micro Motion transmitters and devices:
• Model 1700/2700
• Model 1500/2500
• Model 2400S
• Model 2200S
• Model 7826 and Model 7828 (advanced electronics)
• Core processor and enhanced core processor
• MVD ™ Direct Connect ™
• Series 3000 with 4-wire sensor interface (MVD ™ )
• RFT9739
• RFT9712
• IFT9701/9703
Note: MVD Direct Connect is a direct host meter that does not include a transmitter. However,
ProLink II can be used to communicate with the core processor component in MVD Direct Connect
installations.