Emerson Network Router - Manual (Page 40)

34 ProLink ® II Software for Micro Motion ® Transmitters
Using ProLink II Software
Figure 3-7 Alarm Log window
3.9.2 Acknowledging alarms
To acknowledge an alarm using ProLink II, you must use the Alarm Log window.
To acknowledge an alarm:
1. Choose ProLink > Alarm Log .
2. Select Ack for each alarm you want to acknowledge.
- If the alarm is no longer active (green light), the alarm will be cleared from the list, and the
Alarm Log window will be updated as soon as new data is received from the transmitter.
- If the alarm is still active (red light), the red light will remain, but the name of the alarm
will be grayed out. The alarm will be cleared from the list as soon as it is no longer active.
3.10 Managing the ProLink II license
Both the ProLink II temporary license and permanent license are keyed to a specific disk and a
specific folder or directory on a specific PC. If you want to move the ProLink II installation, you must
use the appropriate license transfer function:
• To Directory is used to transfer ProLink II to another location on the same PC.
• Out of Computer and Into Computer are used to transfer ProLink II to another PC.