Sp. 60, When the or indicators flash orange warning, When the or indicators are off normal – Epson EMP-TWD10 User Manual

Page 62

Advertising
background image

60

Lamp error/Lamp failure/Lamp cuts out/Lamp cover open

Wait for approximately 1 minute and 30 seconds, and check for a
blown lamp.

s

p. 66

Clean the air filter and the air intake vent.

s

p. 63

The lamp is not broken

Reinsert the lamp then turn on the main

power switch on the main unit and press

.

If the condition is not
fixed once the lamp is
re-inserted

The lamp is broken

Contact your dealer for further advice.

s

p. 77

When using this unit at high altitudes, that is 1500 m or more above sea level, set “High Altitude Mode”
to “On”.

s

p. 58

When the

or

indicators flash orange

Warning

: lit

: flashing

: off

High temperature
alarm

You can continue
projecting in this state.
Projection stops
automatically if
subsequent high
temperatures are
registered.

Check the 2 items listed.
• Move this unit away from

the wall at least 20 cm.

• Clean the air filter.

s

p. 63

If there is no improvement when

you press

and switch the

power on, discontinue use and
disconnect the power cable from
the electrical outlet. Contact your
local dealer or the nearest address
provided in the Inquiries.

s

p. 77

Lamp replacement notification

It is time to replace the lamp. Replace the lamp with a new one as soon as possible. Do not continue to
use the lamp in this state, otherwise it may explode.

s

p. 66

When the

or

indicators are off

Normal

: lit

: flashing

: off

Standing-by

Shows that the unit is ready to be used.

During warming
up (Approx. 20
sec)

In warm-up mode, pressing

or

has no effect.

Do not unplug the power cable during warm-up. This may reduce the lifespan of the
lamp.

Projection in
Progress

Cooling down
(Approx. 5 sec)

The operation of all remote control and main unit buttons is suspended during cool-
down. Enters stand-by mode once cool-down has completed.
Do not unplug the power cable during cool-down. This may reduce the lifespan of
the lamp.

Break

Press

to return to normal playback.

Image being
turned Off

The Power switch is on but the projection lamp is off. Press

to turn the

projection lamp on.

Red

If the error continues

s

p. 59

Orange

Green

Orange

Green

Orange

Orange

Green

Green

Green

Green

Green

Green

Green

Orange

Green

Green

Green

Green

Orange

Advertising