P. 66 – Epson EMP-TWD10 User Manual
Page 68
Advertising
66
Replacing the lamp
1
Turn the power switch off, and when a short beep sounds,
unplug the power cable.
2
Insert the screwdriver that supplied with the replacement
lamp into the opening latch of the lamp cover and remove
the lamp cover while keeping the driver inserted.
3
Loosen the lamp attachment screws.
4
Take out the old lamp.
5
Install the new lamp.
Caution
The lamp is hot immediately after use. Once the power has been switched off,
allow approximately one hour to pass before replacing the lamp to allow it to cool
thoroughly.
Advertising