TA Triumph-Adler DC 2216 - Manual (Page 122)

Troubleshooting
9-2 OPERATION GUIDE
If other trouble occurs
Check the following items when trouble occurs. If the problem is not
resolved after checking these items, contact your service representative.
Symptom Items to Check Corrective Procedure
Reference
Page
Nothing displays on
the Operation Panel
even though the
Power Switch is ON. Check to make sure the copier is
plugged into the outlet. Plug the copier power cord into
the outlet. –
No copy is produced
when [Start] is
pressed. Check to see if something has
been displayed on the Operation
Panel. Check the corrective procedure
for the error display and carry it
out. 9-5
Nothing appears on
the copy. Check to see that the original
has been set properly. Place the original face down on
the platen and adjust the Original
Size Indicator Plate to match its
size.
Place the original face up when
setting it in the optional
Document Processor. 3-2
7-3
A light copy is
produced. Check to see if the copier is in
Auto Exposure Mode. When the exposure is to be
changed overall, perform out the
“Auto Exposure Adjustment”. 5-11
Check to see if the copier is in
Manual Exposure Mode. Use Exposure Adjustment to set
the proper exposure. 3-3
When the exposure is to be
changed overall, perform the
Manual Exposure Adjustment in
each original mode. 3-3
Check to see if the toner in the
toner container is canted. Shake the Toner Container left
and right for approximately 10
times. 8-8
Check to see if the Add Toner
Indicator is lit. Replace the Toner Container. 8-5
Check to see if the paper is
damp or not. Replace the paper with new
paper. –
Check to see if the electrical
charge section is dirty or not. Open the front cover and use the
Cleaning Rod to clean the
electrical charge section. 8-7