TA Triumph-Adler DC 2216 - Manual (Page 126)

Troubleshooting
9-6 OPERATION GUIDE
The left cover of the cassette is open. Close the left
cover as displayed in place of #.
Check the key counter and make sure it is set properly. 7-7
No Letter/A4 size paper was available in either the
cassette or the Paper Feeder (MP tray) at the time when
the report was attempted to be output. Press [Paper
Selection] and select the supply cassette, then press
[Start]. Paper will be supplied from the cassette
selected. –
Turn the power switch OFF/ON. Usage will be possible
again once the regular display returns. When A and the
number (A# # # #) are again displayed, make a note of
the A and the number. Turn the power switch OFF,
unplug the power cord and contact your service
representative. –
Copies cannot be produced because memory is full
during the interrupt copy operation. Interrupt Copying
cannot be carried out so press [Stop/Clear] and then
press [Interrupt] again after the data read in has been
deleted to exit the Interrupt Copying.
After the copying operation for the interrupted copy has
been completed, repeat the procedure again. –
Memory is full.
Press [OK] to start outputting the copies read in. Press
[Reset] or [Stop/Clear] to delete the data read in.
Reduce the number of originals and repeat the copying
procedure. –
Check the MP Tray paper. Set paper in the MP Tray in
the event there is no paper present there. When the MP
Tray paper fails to be fed, reset the paper. 2-6
A paper misfeed has occurred. Remove the jammed
paper. 9-9
The copier will try to make copies of the originals it could
not copy before. Return all of the originals to the original
table and try copying them again. –
Display Corrective Procedure
Reference
Page
Close
left cover #.
Insert
key counter.
No matching
paper available.
MainPower Off/On
A####
Memory is full.
Cannot continue.
Memory is full.
Press OK.
MP tray empty.
Add paper.
Paper jam
Place the
original on DP.