Department id code registration, Deleting department id codes, Department id code registration -3 – TA Triumph-Adler DC 2216 User Manual
Page 99: Deleting department id codes -3, Register code, Delete code
Job Accounting
OPERATION GUIDE
6-3
3
After completing each setting, press
U or V
to display 00.Set Completed.
4
Press [OK].
Department ID Code Registration
A Department ID Code of up to 8 digits can be entered.
1
Display the Job Accounting. (Refer to Job Accounting Operations
Procedures on page 6-2.)
2
Press
U or V to display 02.Register
code
.
3
Press [OK].
4
Input the Department ID Code to be registered (up to a maximum of 8
digits) using numeric keys.
Number from 0 to 99999999 can be input.
NOTE:
If a mistake is made during input it can be cleared by pressing
[Stop/Clear] and the value reentered.
5
Press [OK]. The code that was input will flash on and off.
6
After confirming the code that was input, press [OK]. The display will return
to that of Step 2.
NOTE:
If an existing Department ID Code is attempted to be registered,
an error will occur and Already registered. will display in the
message display. In this case, register a different Department ID Code.
Deleting Department ID Codes
Deleting a registered Department ID Code.
1
Display the Job Accounting. (Refer to Job Accounting Operations
Procedures on page 6-2.)
2
Press
U or V to display 03.Delete
code
.
Job Accounting:
00.Set Completed
Job Accounting:
02.Register code
Job Accounting:
03.Delete code