TA Triumph-Adler DC 2216 - Manual (Page 37)

Preparations
OPERATION GUIDE 2-7
2 Adjust the paper width guide to
the width of the paper to be set.
3 Use the paper width guide to push
the paper in until it reaches the
point where it stops.
IMPORTANT: Always straighten out postcards and other types of thick
paper that are curved before using them. There may be cases in which the
feeding operation cannot be carried out due to the quality of the paper.
When loading paper into the MP Tray, set it so that the side which was
facing upwards in its packaging faces downwards. If the front of the paper
is bent backwards, straighten it out before setting it.
Check to make sure there are no creases, etc. in the paper. Creases in the
paper may lead to paper misfeeds.
Inputting MP Tray Size and Media Type
Adjust the paper in the MP Tray and register the paper size using the
Operation Panel. And specifies the media type.
1 Press [Paper Selection] for 3 seconds. The System Menu will be
displayed.
2 Check to make sure that 23.MPTray
Config
is displayed and then press [OK].
System Menu:
23.MPTray Config