TA Triumph-Adler DC 2218 - Manual (Page 88)

Troubleshooting
6-7
System error.
Main switch off / on.
This message is displayed when a malfunction due to noise or the
like or a communication error during printer processing has occurred.
Follow the procedure below.
1 Turn the main power switch off ({). If printer output is being
performed, cancel printing on the computer.
2 Wait more than five seconds and then turn the main power
switch on ( | ). The error is cleared. If printing has been
performed, perform output again.
—
RAM disk error Press GO
An error has occurred in writing to or reading from the RAM disk.
Press the Print key, select
GO
, and press the Enter key. The error
will be cleared.
—
MemoryCard err Press GO
An error has occurred in writing to or reading from the memory card.
Press the Printer key, select
GO
, and press the Enter key. The error
will be cleared.
—
Memory card error Insert
again.
The memory card is accidentally removed during printer setting.
Insert the memory card.
Note
When inserting the memory card, turn the main power switch off ({).
—
Insert same memory card
When the machine has tried to read data from the memory card, it
cannot recognize the memory card.
Insert the memory card again.
Note
When inserting the memory card, turn the main power switch off ({).
—
Format error Memory card
The memory card inserted in the machine must be formatted.
Format the memory card.
—
Print overrun Press GO.
Printing has not been performed properly because of insufficient
memory.
Press the Print key to display the following messages.
GO
: Continues printing.
CANCEL
: Cancels printing.
RESET
: Resets the printer board. In this case, only the printer
functions will be reset.
Press the S key or the T key to select the desired processing and
press the Enter key.
Notes
•
If the auto continue setting has been turned
On
, printing will be
automatically resumed after a preset period of time.
• After this error message is displayed, the page protect mode will
be automatically turned
On
.
—
Interface occupied
The selected interface is currently being used. Wait for a while and retry. —
Checksum Error
The machine has detected an error at startup.
Turn off the main power switch and on again. If the same message
appears, contact your service representative or authorized service
center.
—
Ready to copy
Toner low.
Toner remaining in the machine is low. Prepare a new toner
container. -
Message Procedure Reference
page