Whelen 90206 - Manual

Page 1
®
ENGINEERING COMPANY INC.
Route 145, Winthrop Road,
Chester, Connecticut 06412
Phone: (860) 526-9504
Fax: (860) 526-2009
Internet: www.whelen.com
Sales/Service e-mail: [email protected]
Aviation
Installation Guide
Aviation model 90206 - ( )
Anti-Collision / Position Light Assembly
©1998 Whelen Engineering Company Inc.
Form No.13390B (052206)
1.97
3.06
.51 9.375
10.63
26"
APPROX.
22"
APPROX.
3.75
WINGTIP SKIN
EXISTING
APPROX.
22"
MTG PLATE
SPECIFICATIONS (Position Light):
Nominal Operational Voltage: ...... 28 VDC
Average Input Current: ................. 1 AMP
Lamp for all Units:......................... 28VDC, 26 Watts Max.
EQUIPMENT LIMITATIONS:
An approved Anti-Collision / Position System consists of
two assemblies, one located on each wingtip.
INSTALLATION PROCEDURES:
The following information is to assist you in installing a
Whelen Anti-Collision / Position light system.
1. Choose the appropriate Model 90206 - ( ) replacement
light assembly.
2. The installation procedure described in the following
text will be confined to a single light installation, but is
identical for multiple light installation.
3. Remove old anti-collision light, locate and record
existing +28 VDC and (-) ground position and output
connector from power supply.
4. Use existing mounting holes and hardware.
5. Connect leads from light assembly in recorded
manner and lead from light to power supply.
6. Breaker Requirements
Make sure existing system is equipped with an
appropriate sized breaker.
7. Install light assembly and insure that all leads are clear
of any obstructions and ty-rap as required. Secure
light assembly, use lock washers and/or thread lock,
on all threaded fasteners.
8. Check all avionics systems for interference from this
installation.
9. A flight check should be performed by a properly
certified pilot.
10. When necessary, waterproof the light assembly to
aircraft. Apply single part silicone (RTV) or equivalent
around any open area where water could get in.
11. Update aircraft records and complete Form 337.
12. Obtain FAA field approval for installation.
Model 90206 - ( )
Anti-Collision / Position
Light Assembly
FAA / TSO C30c TYPE 1,2 & 3
and
FAA / TSO - C96a
APPROVED
MADE IN THE U.S.A.