Whelen 9008803 - Manual

Page 1
.670
.936 1.70 1.95
.90 TYP
8.880
6.700
5.00
.203 DIA.
MNTG HOLES
(5 PLACES) SUGGESTED MTG PATTERN
Screw, #10-32 x ½”
Phillips FHMS
Lens Retainer
19-171019-00S
Lens, Red
68-4270569-52 ( )
68-42705 9- ( )
9008804/upper
6 53 9008803/lower
L
38-0270584-00
ens Gasket
B
38-0270864-00
aseplate Gasket
LED
01-0 7 ( )
Assembly
2 1022-00 9008803 & 04
Input Receptacle
MS27508E10A-5P
(as used on models
9008803 & 9008804)
POS. A - +28VDC
POS. B - Ground
POS. C - N/C
POS. D - N/C
POS. E - N/C
2.70
.38 1.84
2.38
.80
9.87
4.86
1.20
OPERATING INSTRUCTIONS:
Operational Voltage: . 28 VDC
Average Input Current: . . . . . . . . 0.56 Amps
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Amps Peak @ .25 Sec.
INSTALLATION PROCEDURES:
The following information is to assist in the installation of a
Whelen LED Ground Recognition Light Assembly.
1. Choose the appropriate 90088( ) replacement light
assembly which is most applicable to your aircraft. Lower
mounts have a drain hole in the lens.
2. The installation procedure described in the following text
will be confined to a single light installation, but is identical
for multiple light installations.
3. Remove the old light, locate and save the existing
+28VDC lead and (-) ground lead. Clean and prep lead
ends as required.
4. Use existing mounting holes and hardware.
NOTE: If a special mounting adapter plate is required,
contact Whelen Aviation Division for requirements.
5. Connect the +28 VDC and (-) ground leads equipped with
an appropriate sized breaker to the LED Light. Both leads
must be connected by an approved FAA connection.
6. Install light assembly and insure that the wire leads are
clear of any obstructions and ty-wrap as required. Use
lock washers and/or thread lock on all threaded fasteners.
7. Check all avionics systems for interference from the
installation.
8. A flight check should be performed by a properly certified
pilot.
9. Update aircraft records, complete Form 337 and obtain
FAA field approval for installation.
Installation Guide:
Model 90088( )-Series
Models: 9008803, 9008804
P/N: 01-0790088-03, 01-0790088-04
LED Ground Recognition Light Assembly
Aviation
©2003 Whelen Engineering Company Inc.
Form No.13858D (60606)
®
ENGINEERING COMPANY INC.
Route 145, Winthrop Road,
Chester, Connecticut 06412
Phone: (860) 526-9504
Fax: (860) 526-2009
Internet: www.whelen.com
Sales/Service e-mail: [email protected]
MADE IN THE U.S.A.