PLANET FGSD-1008HPS - Manual (Page 70)

User’s Manual of FGSD / FGSW Web Smart PoE Switch
70
Figure 4-7-1 STP Port Status Transitions
You can modify each port status by using management software. When you enable STP, every port on every switch in the
network goes through the blocking status and then transitions through the statuses of listening and learning at power up. If
properly configured, each port stabilizes to the forwarding or blocking statis. No packets (except BPDUs) are forwarded from, or
received by, STP enabled ports until the forwarding status is enabled for that port.
2. STP Parameters
STP Operation Levels
The Switch allows for two levels of operation: the switch level and the port level. The switch level forms a spanning tree
consisting of links between one or more switches. The port level constructs a spanning tree consisting of groups of one or more
ports. The STP operates in much the same way for both levels.
On the switch level, STP calculates the Bridge Identifier for each switch and then sets the Root
Bridge and the Designated Bridges.
On the port level, STP sets the Root Port and the Designated Ports.
The following are the user-configurable STP parameters for the switch level:
Parameter Description Default Value
Bridge Identifier(Not user
configurable
A combination of the User-set priority and
the switch’s MAC address.
32768 + MAC