PLANET FGSD-1008HPS - Manual (Page 89)

User’s Manual of FGSD / FGSW Web Smart PoE Switch
89
4.10.3 PoE Port Setting
This section allows the user to inspect and configure the current PoE port settings as Figure 4-10-2 shows.
Figure 4-10-2 PoE Port Configuration Page Screenshot
The page includes the following fields:
Object Description
 Status There are two modes for PoE status.

Enable : Enable PoE function.

Disable : Disable PoE function.
 Mode Allows user to select 802.3at or 802.3af compatibility mode. The default vaule is
802.3at mode.
This function wil affect PoE power reservation on Classification power limit mode
only, as 802.3af mode, system is going to reserve 15.4W maximum for PD that
supported Class3 level. As IEEE 802.3at mode, system is going to reserve 30.8
watts for PD that support Class4 level. From class1 to class3 level on the
802.3at mode will be reserved the same PoE power with 802.3af mode.
 Priority The Priority represents PoE ports priority. There are three levels of power priority
named 1 (Low), 2 (High) and 3 (Critical).
The priority is used in the case when total power consumption has been over
total power budget. In this case the port with the lowest priority will be turn off,
and offer power for the port of higher priority.
 1 : Low mode.
 2 : High mode.
 3 : Critical mode.
 Power Allocation It can limit the port PoE supply watts. Per port maximum value must less than
30.8 watts , total ports values must less than the Power Reservation value. Once
power overload detected, the port will auto shut down and keep on detection
mode until PD’s power consumption lower than the power limit value
 Port No. Select the ports to apply the PoE Port Setting
The PoE Port Status screen in Figure 4-10-3 appears.