PLANET FGSW-2402PVS - Manual (Page 12)

8
# '0 ! ) &
Unlike the unmanaged switch, FGSW-2402PVS/ FGSW-2620PVS performs series smart functions that make
the Switch operate more effectively. This section will describe the common usage of the Switch Smart
Configuration.
Note: The following section will base on the console screens of FGSW-2620PVS, for
FGSW-2402PVS the display will be the same to FGSW-2620PVS.
$ % %
3 #+
When you are ready to configure the smart functions of the Switch, make sure you had connected the supplied
RS-232 serial cable to the RS-232 port at the front panel of your Switch and your PC.
3 03 # $ 3
In Windows 98/2000/XP, launch “HyperTerminal”, create a new connection, and adjust settings as below:
Emulation: VT-100 compatible
Baud per second: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow Control: None
To get a demonstration, please see the figure 3-1.
Figure 3-1 Console Port Settings for smart functions
+ $# % + #
As the Switch powers on, it goes through a self-test process to ensure proper operations of the Switch
hardware. The messages will be displayed to show the test progress. When the test completes successfully,
the system will display a login screen. If any of the components fails during the test, you may need to contact
your local dealer and have the Switch replaced. Figure 3-2 shows a successful Self-test menu of the Power-up
System Self-diagnostic Process.