PLANET FNSW-1602S - Manual (Page 17)

14 15
Figure 3-7 Port Configuration Screen
Speed/duplex 100Full-duplex mode 100Half-duplex mode
Hardware (module) Full-duplex mode Half-duplex mode
Software (firmware) 100 Full 100 Half
Table 3-4 Settings of 100Base-FX module
3.2.3.2 Trunk Configuration
Use the “TAB” key to move the highlight to the Trunk Configuration and press “Enter” to
access the screen of Trunk Configuration from the Switch Configuration screen (please
see the figure 3-5). The screen of Trunk Configuration in Figure 3-8 appears. Table 3-
5 shows the descriptions of the Trunk Configuration screen Objects. The Port Trunking
Configuration menu controls the port trunking or the so-called Link Aggregation function.
Port 1 and Port 2 or Port 9 and Port 10 in the FNSW-1602S Smart Fast Ethernet Switch can
be bundled together to form a high-speed trunk. Use the “TAB” key to choose the <Edit>
and press “Enter”. Then start to modify these settings. Use the “TAB” key to move the
highlight to the selection and press the “Space Bar” key to toggle back and forth between
the options. After setup completed, press “Ctrl-A” key to return to Actions menu and use
the “TAB” key to choose the <Save> for saving the current configuration.
Figure 3-8 Trunk configuration Screen