PLANET ICA-3150 - Manual (Page 44)

ICA-3150
Appendix F: Troubleshooting &
Frequently Asked Questions
Features
The video and audio codec is
adopted in the device. The device utilizes H.264 compressions to provide high quality
images. The device does not build-in the audio.
The maximum number of users
that accesses the device
simultaneously. The maximum number of users is limited to 3. However, it also
depends on the total bandwidth accessed to this device from clients.
The maximum data throughput of the device is around 20~25Mbps
for UDP mode and 10Mbps for HTTP mode. Therefore, the actual
number of connected clients is varying by streaming mode, settings
of resolution, codec type, frame rate and bandwidth. Obviously, the
performance of the each connected client will slow down when many
users are logged on.
The device can be used outdoors
or not. The device is weatherproof. It needs to be equipped with a
weatherproof case for outdoor use.
Installing this device
The network cabling is required for
the device. The device uses Category 5 UTP cable allowing 10 and /
100BASE-TX networking.
The device will be installed and
work if a firewall exists on the
network. If a firewall exists on the network, port 80 is open for ordinary data
communication. The HTTP port and RTSP port need to be opened
on the firewall or NAT router.
The username and password used
for the first time or after factory
default reset Username = admin and password = admin.
Note that it’s all case sensitive.
Forgot the username and
password Follow the steps below.
1. Open the IP Finder II and search this device.
2. Press “Restore Factory” button to restore all settings to factory
default setting.
Forgot the IP address of the
device. Check IP address of device by using PLANET IP Finder program
or set the device to default by reset button.
PLANET IP Finder II program
cannot find the device. z Re-power the device if you cannot find the unit within 1 minute.
z Do not connect device over a router. PLANET IP Finder II
program cannot detect device over a router.
z If IP address is not assigned to the PC running PLANET IP
Finder II program, then PLANET IP Finder II program cannot find
device. Make sure that IP address is assigned to the PC properly.
z Antivirus software on the PC might interfere with the setup
program. Disable the firewall of the antivirus software during
setting up this device.
z Check the firewall setting of your PC or Notebook.
Internet Explorer does not seem to
work well with the device Make sure that your Internet Explorer is version 6.0 or later. If you
are experiencing problems, try upgrading to the latest version of
- 44 -
720P IR Bullet PoE IP Camera