PLANET WNAP-7300 - Manual (Page 16)

2.2 Hardware Installation 2.2 Hardware Installation
2.2.1 Connect up
1. The bottom of WNAP-7300 is a movable cover. Loosen the screw with a Phillips screwdriver.
Grab the cover and pull it out as the figure shown below.
1. The bottom of WNAP-7300 is a movable cover. Loosen the screw with a Phillips screwdriver.
Grab the cover and pull it out as the figure shown below.
- 6 -
Figure 3 Move the Cover
2. Plug a standard Ethernet cable into the RJ45 port labeled “LAN 1”. Do not plug the cable into
the RJ45 port labeled “LAN 2”.
Figure 4 Cable Connection