PLANET WNAP-7300 - Manual (Page 48)

Chapter 5 Management
5.1 SNMP Management
The WNAP-7300 supports SNMP for convenient remote management. Open “SNMP Configuration”
in “Management” shown below. Set the SNMP parameters and obtain MIB file before remote
management.
Figure 33 SNMP Configuration
Enable SNMP
Check this box to enable SNMP settings.
Protocol Version
Select the SNMP version, and keep it identical on the WNAP-7300 and the SNMP manager.
Server Port
Change the server port for a service if needed; however you have to use the same port to use that
service for remote management.