3 pole mounting, Figure 12 pole mounting – step 1 – PLANET WNAP-7300 User Manual
Page 21
- 11 -
Warning:
Users MUST power off the WNAP-7300 first before connecting the external antenna to
it. Do not switch from built-in antenna to the external antenna from WEB management
without physically attaching the external antenna onto the WNAP-7300; otherwise,
damage might be caused to the unit itself.
Follow the steps described in Connect Up to finish the installation.
2.2.3 Pole Mounting
1.
Turn the WNAP-7300 over. Put the pole mounting rings through the middle hole of it. Note that
you should unlock the pole mounting ring with a screw driver before putting it through the
WNAP-7300 as the following right picture shows.
Figure 12 Pole Mounting – Step 1
2.
Mount the WNAP-7300 steadily to the pole by locking the pole mounting ring tightly. The
mounting ring supports pole diameter 32mm to 70mm.