PLANET BT-200U - Manual (Page 27)

23
Appendix A
Trouble Shooting
Q1: CANNOT CONNECT TO A PAIRED DEVICE:
A1: Paired devices are always displayed in My Bluetooth Places, even if the remote
device is out of range or not powered up.
Verify that the remote member of the pair is within radio range and powered up and
then attempt the connection again.
Q2: CANNOT DISCOVER SERVICES ON AN UN-PAIRED REMOTE DEVICE:
A2: The remote device may not be powered up or may be out of range.
§ Verify that the remote device is powered up.
§ Verify that the remote device is in Connectable mode (Bluetooth Configuration
Panel > Accessibility tab).
§ Perform a Search for Devices to verify that the device is within range.
Q3: DIAL-UP NETWORKING SERVICE DOES NOT START:
A3: The Dial-up Networking service will not start unless a properly configured modem
is attached to the server.
§ Verify that the modem is usable as a local device from the server.
§ In the Bluetooth Configuration Panel, Local Services tab, double-click the Dialup
Networking service:
ü Click the down arrow in the Modem field and select the modem that will be
used to dial out.
ü Click the OK button.
ü Click the OK button to close the Bluetooth Configuration Panel.
Q4: HOW DO I DETERMINE THE BLUETOOTH DEVICE ADDRESS (BDA) OF MY
HARDWARE DEVICE?
A4: In the Bluetooth Configuration Panel, on the Hardware tab, in the Devices section,
select the device you want to determine the address of. In the Device Properties
section of the dialog box, the fourth entry, Device Address, is the BDA of the selected
Bluetooth.
Q5: HOW DO I DETERMINE THE VERSION NUMBER OF THE BLUETOOTH
SPECIFICATION THAT THE HOST CONTROLLER INTERFACE (HCI) COMPLIES
WITH?
A5: In the Bluetooth Configuration Panel, on the Hardware tab, in the Device Proper-
ties section, the fifth entry provides Bluetooth Specification compliance information for
the Host Controller Interface.
The sixth entry contains the Specification Revision information for the Host Controller
Interface, if appropriate.
A