Hardware installation – PLANET BT-200U User Manual
Page 9
Installation
5
Hardware Installation
Note: The hardware installation should be only performed when the software is
well installed.
Precaution
Before the installation, make sure the USB port exists in your computer and is enabled.
To check this, go to My Computer
àControl Panel àSystem. Open the Device
Manager tab. If the Universal Serial Bus controller device is found, it means your
USB port is installed and enabled. If not, either no USB port is installed or the USB
bios is not properly enabled. In this case, consult your computer dealer for USB sup-
port.
Getting Hooked Up
1.
Locate the USB host port of your system. Align the USB connector (the thinner
end) of the USB adapter toward the USB host port, push evenly and steadily until
it is seated.
2.
Plug your BT-200U into the thicker end of the USB adapter cable.
Connects to the USB host port