PLANET WNRT-627 - Manual (Page 149)

User’s Manual of WNRT-627
-149-
1. Sometimes the connection cannot be disconnected although you specify a
time to Max Idle Time, since some applicants are visiting the Internet
continually in the background.
2. If you are a Cable user, please configure the Router by following the above
steps.
2. How do I configure the Router to access Internet by Ethernet users?
1) Login to the Router, click the “Network” menu on the left of your browser, and click "WAN"
submenu. On the WAN page, select “Dynamic IP” for "WAN Connection Type", finish by
clicking “Save”.
2) Some ISPs require that you register the MAC Address of your adapter, which is connected to
your cable/DSL Modem during installation. If your ISP requires MAC register, login to the
Router and click the "Network" menu link on the left of your browser, and then click "MAC
Clone" submenu link. On the "MAC Clone" page, if your PC’s MAC address is proper MAC
address, click the "Clone MAC Address" button and your PC’s MAC address will fill in the
"WAN MAC Address" field. Or else, type the MAC Address into the "WAN MAC Address" field.
The format for the MAC Address is XX-XX-XX-XX-XX-XX. Then click the "Save" button. It will
take effect after rebooting.
Figure A-2 MAC Clone
3. I want to use Netmeeting, what do I need to do?
1) If you start Netmeeting as a host, you don’t need to do anything with the Router.
2) If you start as a response, you need to configure Virtual Server or DMZ Host and make sure
the H323 ALG is enabled.
3) How to configure Virtual Server: Log in to the Router, click the “Forwarding” menu on the left
of your browser, and click "Virtual Servers" submenu. On the "Virtual Servers" page, click
Add New…. Then on the “Add or Modify a Virtual Server Entry” page, enter “1720” for the