PLANET WNRT-627 - Manual (Page 44)

User’s Manual of WNRT-627
-44-
5.5 Network
There are three submenus under the Network menu (shown in Figure 5-8 ): WAN, LAN, and MAC
Clone. Click any of them, and you will be able to configure the corresponding function.
Figure 5-8 The Network menu
5.5.1 WAN
Choose menu “Network→WAN”, you can configure the IP parameters of the WAN on the screen
below.
If you don't know how to choose the appropriate connection type, click the Detect
button to allow the Router to automatically search your Internet connection for servers
and protocols. The connection type will be reported when an active Internet service is
successfully detected by the Router. This detect result is for your reference only. To
make sure the connection type your ISP provides, please refer to the ISP. The various
types of Internet connections that the Router can detect are as follows:
PPPoE - Connections which use PPPoE that requires a user name and
password.
Dynamic IP - Connections which use dynamic IP address assignment.
Static IP - Connections which use static IP address assignment.
The Router cannot detect PPTP / L2TP / BigPond connections with your ISP. If your ISP
uses one of these protocols, then you must configure your connection manually.
 Dynamic IP
1. If your ISP provides the DHCP service, please choose Dynamic IP type, and the Router will
automatically obtain IP parameters from your ISP. You can see the page as follows ( Figure 5-9 ):