PLANET ICA-107 - Manual (Page 10)

2.3. Installation Procedure
1. Unpack the package and verify that all the items listed in the Chapter 2 are available.
2. Connect the IP Camera to your network with network cable; please connect the IP camera to your
network switch or router.
3. Connect the power adapter to IP Camera and plug the power adapter to power outlet. The IP
Camera will be powered on. When the IP Camera is ready, the Power LED will light on.
4. Make sure that you have installed the ActiveX utility.
Note: It is highly recommended to use the power adapter shipped with the IP Camera, DO NOT use
any other power adapter from other sources. It may make the IP Camera damage.
2.3.1. Locate the IP Address of this IP Camera
Default IP address of this IP camera is 192.168.0.20. If you wish to assign another IP address to this IP
camera, you have to log onto the web configuration interface of the camera first.
If the left three fields of the IP address of your computer is not 192.168.0, you’ll have to change the IP
address of your computer first:
1. Click Start Î Control Panel
6