PLANET ICA-HM127 - Manual (Page 41)

40
‐
DHCP IPv4 / IPv6: Obtain both IPv4 and IPv6 address from DHCP
server on LAN automatically.
‐
Static IPv4 / IPv6: Assign an IPv4 / IPv6 address to IP camera
manually. If you don’t have a DHCP server on your local area
network, you must use this option to specify an IP address.
 IP Address(IPv4): Input IPv4 IP address*
 IP Address(IPv6): Input IPv6 IP address*
 Prefix Length: Input IPv6 IP address’ prefix length (0-128)
 Subnet Mask: Input subnet mask
 Gateway: Input gateway address
 Primary DNS: Input DNS server’s IP address
 Secondary DNS: Input backup DNS server’s IP address, you
can leave this field blank.
*You can leave this field blank, if you only wish to use IPv4 or
IPv6 IP address.
‐
Enable UPnP Discovery: Check this b ox to enable other devices on
network to discover the presence of this IP camera by UPnP. It’s
recommended to enable this function.
‐
Enable UPnP Port Mapping: When UPnP is enabled, check this box
to enable UPnP’s port mapping.
PPPoE Select this option to use PPPoE to connect to network. You have to input
PPPoE username and password assigned by network operator to get
connected.
HTTP Port Input IP camera’s web connection port number here. When this port
number is changed, you need to change web browser’s port number you
used to connect to IP camera.
For example, IP camera’s IP address is 192.168.1.1, and if you changed
HTTP port number to 82, please input ‘http://192.168.1.1:82’ in web
browser’s address bar to access IP camera’s web configuration interface.
RTSP Port Input RTSP port number. When this port number changes, you must
change corresponding settings in external network devices (NVR or CMS
software) so they can receive this IP camera’s video.
RTP Data Port Input RTP data port number here.
When you finish with above settings, click ‘Apply’ button to save changes.