ProSoft Technology MVI69L-MBTCP - Manual (Page 52)

MVI69L-MBTCP Configuration MVI69L-MBTCP ♦ CompactLogix Platform
User Manual Communication Module
Page 52 of 152 ProSoft Technology, Inc.
January 6, 2014
3.2.3 MBTCP Client x
This section defines the general configuration for MBTCP Client x. Up to 10
MBTCP Clients can be configured, each using the parameters below.
Parameter Value Description
Enabled Yes or No Enables this client
Start Active Yes or No Specifies whether to start with commands active on boot up
Error/Status Pointer -1 to 239 Specifies the starting register location in the module’s
database for the error/status table for this client. If a value
of -1 is entered, the error/status data will not be placed in
the database.
All other valid values determine the starting location of the
data. This data should be placed within the read data range
of module memory.
Command Error
Pointer -1 to 239 Specifies the address in the module’s database where the
command error data will be placed. If the value is set to -1,
the data will not be transferred to the database. This data
should be placed within the read data range of module
memory.
Minimum Command
Delay 0 to 65535
milliseconds Specifies the number of milliseconds to wait between
receiving the end of a server's response to the most recently
transmitted command and the issuance of the next