ProSoft Technology AN-X-AMX - Manual (Page 12)

Page 8 AN-X-AMXRIO November 2011
If AN-X does not find a DHCP server within about three minutes of starting up, it reverts
to a temporary static IP address of 192.168.0.41 If AN-X is using this temporary IP
address, it repeatedly flashes the SYS LED three times followed by a pause.
IMPORTANT!
Use this temporary IP address only for initial setup of AN-X. AN-X will
not function for its intended purpose at the temporary IP address.
If you are using multiple AN-X modules, configure one at a time, especially if there is no
DHCP server on the network, since they will all revert to the same temporary IP address
when they fail to find a DHCP server.
IMPORTANT!
If you are connecting AN-X to an existing Ethernet network, consult the
network administrator to obtain a static IP address for AN-X and to
obtain information about how you should configure AN-X and.
IMPORTANT!
The AN-X must be on the local Ethernet (same subnet as your computer)
when you set its IP address.
You configure the Ethernet properties using the Windows utility AnxInit supplied with
AN-X. You can also set the IP address through the web interface. Refer to page 43.
Use the Configuration/AN-X IP Settings command to start the AN-X IP configuration
wizard, which takes you step by step through the IP configuration process.
Step 1
In step 1, you identify the AN-X you are configuring.