ProSoft Technology AN-X-AMX - Manual (Page 22)

Page 18 AN-X-AMXRIO November 2011
7. Set the Input Assembly Instance to 1. Normally you set the size to the
maximum allowed, 250 words. You can set it to a smaller value but it should
be large enough to allow all the input data to pass.
8. Set the Output Assembly Instance to 2. Normally you set the size to the
maximum allowed, 248 words. You can set it to a smaller value but it should
be large enough to allow all the output data to pass.
9. Set the Configuration Assembly Instance to 4. Set the size to 0.
10. Set the Status Input Assembly Instance to 5. Set the size to 26, since the AN-
X-AMXRIO produces 26 words of status input data.
11. Set the Status Output Assembly Instance to 6. You cannot set the size.
12. Click Next > to display the second Module Properties dialog box
Connection Parameters
13. Set the module Requested Packet Interval (RPI). This is how often the
module’s scheduled data is updated in the processor. The value can range
from 5.0 to 3200.0 ms.
14. Click Finish >> to complete the module configuration.