ProSoft Technology AN-X-AMX - Manual (Page 39)

AN-X-AMXRIO Page 35
1. Select the Ethernet adapter that’s connected to the AN-X. In most cases there will be
just one Ethernet adapter in the computer. The AN-X must be on the same subnet as the
computer.
2. Enter the MAC address of the AN-X you are updating. This is printed on the AN-X
label. It consists of six pairs of hexadecimal digits, separated by hyphens. In the
example above, it’s 00-0c-1a-00-00-09.
If the AN-X is already online, you can obtain its MAC address using the Utilities/Locate
All AN-X Modules
command.
3. Enter the IP address of the AN-X you want to update
Step 2
In step 2, you choose a method of restarting AN-X to put it in config mode.