ProSoft Technology AN-X-AMX - Manual (Page 13)

AN-X-AMXRIO Page 9
1. Select the Ethernet adapter that’s connected to the AN-X. In most cases there will be
just one Ethernet adapter in the computer. The AN-X must be on the same subnet as the
computer.
2. Enter the MAC address of the AN-X you are configuring. This is printed on the AN-X
label. It consists of six pairs of hexadecimal digits, separated by hyphens. In the
example above, it’s 00-0c-1a-00-00-0a.
If the AN-X is already online, you can obtain its MAC address using the Utilities/Locate
All AN-X Modules
command.
3. Enter the IP address you intend the AN-X to use.
Step 2
In step 2, you choose a method of restarting AN-X to put it in boot mode.
The preferred method is to cycle power on the AN-X. Select the first option on the
screen and click the Next >> button.
The second method, useful if the AN-X in not easily accessible, is to send it a command
over Ethernet. The AN-X must be powered on and completely running for this method to
work. For example, if this is the first time you are configuring a new AN-X, allow
sufficient time for it to acquire an IP address from a DHCP server or to time out and use
its default IP address (about 3 minutes). Select the second option on the screen and click
the Next >> button.