Fusion F300S User Manual
Page 77
Advertising
Installation, Operation, and Maintenance Manual # 509252 Rev R
77
Lamp Control at
LAMP ON
LAMP OUT
indicator does
not light, or UV
lamp does not
light
Control card
Replace control card.
Arcing sound
from irradiator,
a grinding
noise
Damaged Reflector
Disconnect all power. Inspect reflector for
pitting near large slots. Replace reflector if
necessary.
Wiring or connector
Remove irradiator cover and inspect wiring
for damage.
Magnetron
.
System not
responding in
accordance
with
programming
switch SW1
settings
Incorrect
MASTER/SLAVE
arrangement or
cable hook up
Chapter 3, “Electrical System”
Table 18. Troubleshooting/Fault Diagnosis (continued)
Operation
Signal/
Other
Symptoms
Possible Cause
Corrective Action
Advertising
This manual is related to the following products: