Figure 24. reflector screw tightening sequence, G to, Figure 23 – Fusion F300S User Manual
Page 84: Remo
84
F300S/F300SQ Ultraviolet Lamp System
7. Align the reflector squarely over the opening. With gentle pressure and a rocking
motion, slide the reflector down in place. It should not bind against the end
reflectors as it goes into place. As a final motion, grasp the sides of the reflector
and gently force them together a small amount, then settle the reflector down
over the mounting surfaces (
). Start the six flat head screws in the
reflector but do not tighten. Tighten the six screws in the sequence 1-6 as shown
in
to a snug position; finally tighten to 3.4 N-m (30 inch-lbs.) using a
torque controlled screwdriver. Repeat tightening the screws as illustrated and at
the specified torque.
Figure 23. Reflector Removal or Replacement (I300M)
Figure 24. Reflector Screw Tightening Sequence