Fluke THE HART 1529 - Manual (Page 103)

<volt> parameter is always in mV. The response to this command is a tempera-
ture in the currently selected units. The current system units determine the scale
of the response.
8.4.5 Calibration Coefficient Commands
The calibration coefficient commands are used for querying and setting the
channel calibration date, due date, linearity, offset, scale, and RJC.
8.4.5.1 CALibrate:AUTo
Executes the automatic calibration procedure when using Fast Measurement
Mode (see Sections 6.9, Fast Measurement Mode, 7.1.1, Measure Period and
Fast Measurement Mode, and 7.1.5, Display Functions/Auto-Cal).
CAL:AUT
8.4.5.2 CALibrate<chn>:DATE:CALibrate? [MIN|MAX|DEF]
Returns the calibration date for the specified channel.
CAL1:DATE:CAL?
2000,9,22
The CALibrate suffix, <chn>, specifies the channel (1 to 4). This command
does not apply to memory channels. The response is returned in the format,
<year>,<month>,<day>. Specifying the MIN parameter returns a value of
2000,1,1. Specifying the MAX parameter returns a value of 2099,12,31. Spec-
ifying the DEF parameter returns a value of 2000,1,1.
8.4.5.3 CALibrate<chn>:DATE:CALibrate
(<year>,<month>,<day>)|MIN|MAX|DEF
Sets the calibration date for the specified channel.
CAL1:DATE:CAL 2000,8,29
The CALibrate suffix, <chn>, specifies the channel (1 to 4). This command
does not apply to memory channels. The <year>, <month>, and <day> parame-
ters must all be supplied. The <year> parameter is a four-digit number (2000 to
2099). The <month> parameter is a one or two-digit number (1 to 12). The
<day> parameter is a one or two-digit number (1 to 31). Specifying the MIN,
MAX or DEF parameter sets the calibration date to the minimum, maximum,
or default value respectively.
This command is password-protected. To access this command, the password
must be successfully entered using the SYST:PASS:CEN <pass> command
(see Section 8.4.11, Password Commands).
8.4.5.4 CALibrate<chn>:DATE:DUE? [MIN|MAX|DEF]
Returns the recalibration date for the specified channel.
97
8 Digital Communications Interface
Commands