Fluke THE HART 1529 - Manual (Page 118)

1
A value of 1 is returned if serial port echo (duplex) is ON. A value of 0 is re-
turned if serial port echo (duplex) is OFF. Specifying the MIN parameter re-
turns a value of 0. Specifying the MAX parameter returns a value of 1.
Specifying the DEF parameter returns a value of 1.
8.4.9.4 SYSTem:COMMunicate:SERial:FDUPlex <bool>|MIN|MAX|DEF
Sets the serial port echo (duplex) setting.
SYST:COMM:SER:FDUP MAX
The <bool> parameter turns serial port echo (duplex) mode on (1 or ON) or off
(0 or OFF). Specifying the MIN, MAX, or DEF parameter sets the serial port
echo (duplex) to the minimum, maximum, or default respectively.
8.4.9.5 SYSTem:COMMunicate:SERial:FEED? [MIN|MAX|DEF]
Returns the state of the serial port printing.
SYST:COMM:SER:FEED?
0
A value of 1 is returned if serial port printing is enabled. A value of 0 if re-
turned is serial port printing is disabled. Specifying the MIN parameter returns
a value of 0. Specifying the MAX parameter returns a value of 1. Specifying
the DEF parameter returns a value of 0.
8.4.9.6 SYSTem:COMMunicate:SERial:FEED <bool>|MIN|MAX|DEF
Sets the state of the serial port printing.
SYST:COMM:SER:FEED DEF
The <bool> parameter turns serial printing on (1 or ON) or off (0 or OFF).
Specifying the MIN, MAX, or DEF parameter sets the serial port printing value
to the minimum, maximum, or default respectively. The *RST command sets
the serial port printing to OFF.
8.4.9.7 SYSTem:COMMunicate:SERial:LINefeed? [MIN|MAX|DEF]
Returns the state of the serial port linefeed setting.
SYST:COMM:SER:LIN?
1
A value of 1 is returned if linefeed is enabled. A value of 0 is returned if line-
feed is disabled. Specifying the MIN parameter returns a value of 0. Specifying
the MAX parameter returns a value of 1. Specifying the DEF parameter returns
a value of 1.
1529 Chub-E4 Thermometer Readout
User’s Guide
112