Fluke THE HART 1529 - Manual (Page 111)

24
Specifying the MIN parameter returns a value of 1, Specifying the MAX pa-
rameter returns a value of 25. Specifying the DEF parameter returns a value of
1.
8.4.7.6 LOGging:AUTomatic:LABel <num>|MIN|MAX|DEF
Sets the current auto log label.
LOG:AUT:LAB 4
The <num> parameter specifies the auto log label number (1 to 25) to select.
Specifying the MIN, MAX, or DEF parameter sets the auto log label to the
minimum, maximum, or default respectively.
8.4.7.7 LOGging:AUTomatic:POINt? [MAX]
Returns the number of auto log entries already stored.
LOG:AUT:POIN?
28
Specifying the MAX parameter returns the total number of entries that can be
stored in the auto log.
8.4.7.8 LOGging:AUTomatic:PRINt [<num>|ALL [,<port>]]
Prints the auto log entries.
LOG:AUT:PRIN ALL
DATA_25 1 22.676C 12:19:42 09-05-00
DATA_25 2 9.960 KO 12:19:44 09-05-00
DATA_25 3 23.220C 12:19:46 09-05-00
DATA_25 4 23.245C 12:19:48 09-05-00
DATA_25 1 22.765C 12:19:52 09-05-00
DATA_25 2 9.962 KO 12:19:54 09-05-00
DATA_25 3 23.087C 12:19:56 09-05-00
DATA_25 4 23.260C 12:19:58 09-05-00...
If no parameters are specified, the ALL parameter is assumed and all auto log
entries are printed to the serial port. Specifying the <num> parameter prints
only the log entries with the specified label number to the serial port. Op-
tionally, the log entries may be printed to a specific port by specifying the
<port> parameter (see Table 10 on page 125, Port Numbers).
8.4.7.9 LOGging:AUTomatic:STATus?
Returns the auto log status.
LOG:AUT:STAT?
105
8 Digital Communications Interface
Commands