Fluke THE HART 1529 - Manual (Page 119)

8.4.9.8 SYSTem:COMMunicate:SERial:LINefeed <bool>|MIN|MAX|DEF
Sets the state of the serial port linefeed setting.
SYST:COMM:SER:LIN ON
The <bool> parameter turns linefeed on (1 or ON) or off (0 or OFF). Spec-
ifying the MIN, MAX, or DEF parameter sets the linefeed to the minimum,
maximum, or default respectively.
8.4.9.9 SYSTem:COMMunicate:SERial:TIMe? [MIN|MAX|DEF]
Returns the serial port sample period setting.
SYST:COMM:SER:TIM?
1
Specifying the MIN parameter returns a value of 0.1. Specifying the MAX pa-
rameter returns a value of 3600. Specifying the DEF parameter returns a value
of 1.
8.4.9.10 SYSTem:COMMunicate:SERial:TIMe <num>MIN|MAX|DEF
Sets to serial port sample period setting.
SYST:COMM:SER:TIM 10
The <num> parameter can be one of the following values: 0.1, 0.2, 0.5, 1, 2, 5,
10, 30, 60, 120, 300, 600, 1800 or 3600. The units are seconds. If a value other
than one listed here is used, the instrument automatically selects the nearest ac-
ceptable value that is less than the value entered. Values greater than 3600 or
less than 0.1 are ignored. Specifying the MIN, MAX or DEF parameter sets the
sample period setting to the minimum, maximum, or default value respectively.
8.4.9.11 SYSTem:KLOCkout? [MIN|MAX|DEF]
Returns the state of the keypad lockout.
SYST:KLOC?
0
A value of 1 is returned if the keypad is locked out. A value of 0 is returned if
the keypad is enabled (unlocked). Specifying the MIN parameter returns a
value of 0. Specifying the MAX parameter returns a value of 1. Specifying the
DEF parameter returns a value of 0.
8.4.9.12 SYSTem:KLOCkout <bool>|MIN|MAX|DEF
Sets the state of the keypad lockout.
SYST:KLOC 1
113
8 Digital Communications Interface
Commands