Fluke TRACKERTM 90100 - Manual (Page 14)

Model 90100
Operators Manual
2-2
WARNING
WARNING
CAUTION
2.2.1 Powering the System
The Model 35360A TRACKER Display may be operated from either line or battery power. The line
receptacle at the rear panel of the Model 35360A TRACKER Display mates with a 3-wire line cord to
provide a connection to line voltage (high, neutral and earth ground).
When powering the 35360A TRACKER Display
from an AC line, always use a 3-wire grounding
type line cord such as the one supplied with the
90100 TRACKER System. In addition, only
connect the 35360A TRACKER Display to an AC
power outlet employing a third wire safety ground.
Failure to ground the Model 35360A TRACKER
Display may result in personal injury or death in the
event of a short circuit or malfunction.
The 35360A TRACKER Display operates on battery power for eight hours after a full charge. The
35360A TRACKER Display can be recharged quickly, usually in two to three hours, even during
instrument operation. A low battery annunciator is displayed when 30 minutes or less of operation
remains. When the battery pack is fully discharged, the instrument automatically shuts off and will not
operate until AC line power is connected.
The Model 35360A TRACKER Display operates from line voltage ranging from 100 to 240 VAC without
operator switching. An IEC 320/C13 style receptacle provides worldwide operation by simply changing
line cords.
2.2.2 Detector Input
The Model 35360A TRACKER Display connects to the Model 35300A Detector through an interface
cable. The cable connects to an 8-pin D connector on the back of the 35360A TRACKER Display
housing (see Figure 2-1).
Before you attach the 35300A Detector to the 35360A TRACKER Display, you must perform the following
procedure (refer to Figure 2-2 and Figure 2-3).
1. Turn the 35360A TRACKER Display OFF.
Always turn the Model 35360A TRACKER Display's
power off prior to connecting or disconnecting the
interface cable. Failure to do so may result in an
electrical shock.
2. Firmly press the 8-pin D connectors at either end of the interface cable into the 35360A TRACKER
Display and the 35300A Detector, see Figure 2-2 and Figure 2-3.
This interface cable has different mating pins for
both the 35300A Detector and 35360A TRACKER