Fluke TRACKERTM 90100 - Manual (Page 22)

Model 90100
Operators Manual
2-10
2.4.6 Using the AIR DENSITY Button
Pressing the AIR DENSITY button displays the Air Density screen, see Figures 2-12 and 2-13. This
screen contains the temperature value, pressure value, and Air Density Correction Factor (ADCF). Press
the AIR DENSITY button to advance the "X" cursor to the next field. To change the value or state of an
item at the "X" cursor, use the UP and DOWN arrows. The 35360A TRACKER Display displays the Air
Density Correction (ADC) annunciator in the upper left-hand corner of most screens if the air density
correction is enabled, see Figure2-12.
Figure 2-12. The Air Density Screen With Air Density Corrections Enabled
To disable the air density correction, advance the "X" cursor to the ADC annunciator at the upper left of
the VFD. With the "X" cursor at this position, pressing the UP and DOWN keys will toggle the air density
correction on and off.
Figure 2-13. The Air Density Screen With Air Density Corrections Disabled
2.4.7 Using the GAIN SELECT Button (Normal Mode)
Pressing the GAIN SELECT button displays the Gain Select screen, see Figures 2-14 and 2-15. This
screen displays the five Front Panel Gain Factors (FPGF) and the Front Panel Gain annunciator "FPG".
The "X" cursor points to the FPG annunciator.
Figure 2-14. The Gain Select Screen With the Front Panel Gain Enabled
Figure 2-15. The Gain Select Screen With the Front Panel Gain Disabled