Fluke TRACKERTM 90100 - Manual (Page 57)

Appendix
Using Build-Up
A
A-1
Appendix A
Using Build-Up
A.1 Build-Up, Peg, and Retainer Kit Options
If you want to use build-up to simulate tissue, you can put plates of either "solid water" or acrylic (optional
accessories) securely on one or both sides of the Model 35300A Detector. Build-up pegs and retainer
rings for securing the acrylic plates to the 35300A Detector are also available as optional accessories
(see Figure A-1). The build-up pegs (a set of eight) screw into threaded holes in the 35300A Detector,
(four build-up pegs can be installed on each side of the 35300A Detector). The retainer rings are held in
position with set screws that are turned with a hex wrench also included with the Model 90100 TRACKER
System.
Figure A-1.
Installation of Pegs, Build-up and Retainer Rings
Build-up
Retainer rings
Hex wrench tightens set
screw on retainer ring
Threaded pegs
screw into
35300A Detector
Model 35300A Detector