Fluke TRACKERTM 90100 - Manual (Page 47)

Customization
Introduction
5
5-1
CAUTION
Section 5
Customization
5.1 Introduction
From the factory, the Model 35360A TRACKER Display arrives with valid settings allowing you to make
measurements immediately. Should the need arise to change or modify any of the Items described
below, the Customization software provides a friendly environment for customizing the 35360A
TRACKER Display to meet your needs. The Customization software allows you to modify the power
down interval, temperature and pressure units, an optional message, serial number of the detector you
are using with the 35360A TRACKER Display, units of calibration for the detector, and the 35360A
TRACKER Display's units and units conversion. Additionally, the electrometer gains and zeros, and the
ion chamber calibration factors may be changed.
The basic features of the Customization software are its ease of use, an on-line help facility, printer
support, and of course full customization capability for the 35360A TRACKER Display.
The Customization software has the following requirements:
• IBM Personal Computer or compatible
• EGA or VGA display
• one floppy drive (5¼ or 3½ inch)
• DOS version 3.0 or higher
• 512k memory
• one serial port (COM1: or COM2:)
If you want to produce a record of the customized items, you must also have a printer and printer port
(LPT1:).
Do not use this software until you are fully familiar
with both the setup and operation of the Model
90100 TRACKER System. A complete
understanding of the Basic Operating Equations
Quantities as contained in Sections 3.5 and 3.6 of
this manual is an important prerequisite for
adjusting the electrometer gains and offsets.