Matsushita CF-T5LWETZ1 2 - Manual (Page 32)

32
9.3.2.4. Putting LCD Side Dumpers
9.3.2.3. Putting TP Flexible Protection Tape
LCD Side Dumper
LCD
LCD insulator LCD insulator
Put the Side Dumper
There is a possibility to destroy the prism lens
when pressurizing too much when the both sides
tape is affixed
The rib match of thick one.
The edge side match of a thick part.
Overflow NG to the rear side in front of overflow OK
Substrate externals
standard
Frame externals
standard
LCD Side Dumper
TP Flexible cable
protection tape
Sub-materials tape 30mm
The tape is turned inside out.because
the tape of the sub-materials begins to
see from Flexible cable is turned as
shown,sticking side is lost.
Upper : The tape is matched to the edge
of the glass. It does not overflow.
Right and left :
The tape is matched to Flexible cable’s
right edge.It does not overflow.
Upper : Near in the under putting of
tape.
Do not get on and do not go up.
Right and left :
It is matched to Flexible cable right edge.
it does not overflow.