Assembly of the keyboard – Matsushita CF-T5LWETZ1 2 User Manual
Page 65
65
Heat Sheet KB(largeness)
Heat Sheet’s KB (largeness) affixation
Keyboard
Edge side match of keyboard hole
Edge side match of keyboard hole
Inclination 0.5mm or less
Inclination 0.5mm or less
Tape
Tape
KB FPC is bent
(bend on inside)
The bend must use the axis of 2mm or more in the diameter
(The bend of 2mm or less might be disconnected. )
Run side by side with the keyboard externals
(inclination 1mm or less)
3.Bend of two sided tape putting and KB FPC
Keyboard externals match
The gap is outside NG.
Hole part match
(KB plate Sheet’s over part is set at the left of the hole)
4.
Affixation of KB plate
Edge side of round
length hole and
externals of FPC match
0.5mm or less in the inside
Flake off, and use a two sided tape newly
when you recycle the keyboard.
Concave side
KB Plate Sheet
KB Plate
1.
KB Plate assembly
KB Plate / KB Plate Sheet /Tape affixation
Tape
2.Both sides tape affixation
9.3.6.6. Assembly of the Keyboard