Assembly of the wwan board, Putting tapes for wm cable – Matsushita CF-T5LWETZ1 2 User Manual
Page 43
43
WWAN Board
WM Cable
Screw
Screw
Screw
REAR wall application
LCD Hook WAN
LCD Hook Wan installation standard
Connection
REAR wall application
There is no order specification
excluding a specified part.
The oreder of tightening screw (LCD Hook WAN) :
The oreder of tightening screw (WWAN Board) :
9.3.2.16. Assembly of the WWAN Board
Refer to Figure 1
The cable must not stretch.
The cable must not stretch.
The cable must not stretch.
A two sided tape of the cable after the cable position
of Figure 1 is put out is affixed (cable fixation).
A two sided tape of the cable after the cable position
of Figure 1 is put out is affixed (cable fixation)
<Figure 1>
The convex REAR part is set to the cable bundling part
Conductive cloth
Conductive cloth
edge standard
Bundling edge standard 5-8mm
Conductive cloth
must not hang to PET TAPE
about 15mm
about 15mm
about 15mm
Safety work
PET TAPE
Root fixation
9.3.2.17. Putting Tapes for WM Cable