Matsushita CF-T5LWETZ1 2 - Manual (Page 73)

73
Safety work
Edge Guard Tape is put.
Edge Guard Tape is put on
the point of 1mm on the edge
of the module land.
Hide the side of the shield
board in the module after
the Edge Guard Tape putting.
Antenna connector connection
After the module is inserted and
then the screws are tightened.
Cable Fixed Sheet
SCREW
(DFHE5025XA)
<Notes when module is inserted>
The card shall be inserted and separated correctly according to the direction and the process as shown below.
1. The card shall be inserted or separated with the right parallel to or inclined up to against the mounted board.
2. The card shall be inserted completely.
9.3.6.18. Assembly of the WWAN Module