MRV Communications EM316SW-XY - Manual (Page 28)

Fiber Driver
®
EM316SW-XY
PN 1288003-001, Rev D2
20
3.3.3.2 Mylar Tab SFP Modules
The Mylar tab or nail latch on the module has a tab that you must pull in order to remove the
module from a switching module port.
Figure 16 -- Mylar Tab on SFP Module
3.3.3.2.1 Inserting a Mylar Tab SFP Module
To insert the Mylar tab SFP module into a switching module port, line up the SFP module
with the port, and slide it into place
Figure 17 -- Insertion of a Mylar Tab SFP Module
3.3.3.2.2 Removing a Mylar Tab SFP Module
To remove the SFP module from the switching module port, pull the tab gently until the SFP
module disengages from the port, and then pull the SFP module out.
Figure 18 -- Removal of a Mylar Tab SFP Module
Caution When pulling the tab to remove the SFP module, be sure to pull in a straight outward
motion. Do not twist or forcibly pull the tab because you may disconnect it from the SFP module.