MRV Communications EM316SW-XY - Manual (Page 34)

Fiber Driver
®
EM316SW-XY
PN 1288003-001, Rev D2
26
4.3.1 EM316LNXNM-OT Boot and CLI Login
The box below shows the NM boot and login to the built-in admin user account. The “banner”
information that displays after the login may also be displayed from the CLI prompt with the
show version
command. The show command is introduced in a later section. Refer to
EM316LNXNM-OT documentation for network manager and CLI configuration help.
U-Boot 1.0.1 (Jan 25 2005 - 11:08:25)
CPU: MPC875ZPnn at 133 MHz: 8 kB I-Cache 8 kB D-Cache FEC1 FEC2
BOARD: MRV NM2 v3
DRAM: (64 MB SDRAM) 64 MB
FLASH: 16.5 MB
Net: FEC ETHERNET
Hit any key to stop autoboot: 0
## Booting image at e0000000 ...
Image Name: EM316LNXNM
Image Type: PowerPC Linux Multi-File Image (gzip compressed)
Data Size: 7322655 Bytes = 7 MB
Load Address: 00000000
Entry Point: 00000000
Contents:
Image 0: 676629 Bytes = 660.8 kB
Image 1: 6646011 Bytes = 6.3 MB
Verifying Checksum ... OK
Uncompressing Multi-File Image ... OK
Loading Ramdisk to 03920000, end 03f768fb (6568fb)... OK
Welcome to MRV EM316LNXNM
Reading configuration: ok
Starting up, please wait
FPGA Already Loaded.
MRV EM316LNXNM
login: admin
Password:
Please wait, initializing...now ready.
EM316LNXNM-OT v4.0 fdr 58 (Jul 25 2007 - 09:34:25).
U-Boot 1.0.1 (Jan 25 2005 - 11:08:25).
Linux kernel v2.4.26 (#1 Wed Dec 13 10:36:44 PST 2006).
EM316LNXNM (firmware 5c.13) (00:20:1a:02:48:28).
MegaVisionJ v2.34k6 - July 5, 2007 (FiberDriver v1.61j)
Copyright (c) MRV Corp. 1993-2007
You are a SUPER user!
fiberdriver#